Metairie, LA
A Metairie Timberline HDZ roof replacement along a capped hip
A Metairie replacement with HDZ and ridge-cap products specified in the signed scope, plus a close photograph of the shingles, hip, gutter edge, and roof penetrations.
Completion recorded
What the signed proposal included
- GAF Timberline HDZ field shingles
- GAF Seal-A-Ridge caps
- Intake and attic ventilation components
Roof details and scope
This Metairie project paired GAF Timberline HDZ field shingles with Seal-A-Ridge caps in the signed scope. Intake and attic ventilation were also listed. The selected shingle color was still marked to be determined in the reviewed agreement, so the case describes the material without assigning a branded color from the photograph.
The August image follows a long capped hip toward the upper roof. Shingle courses extend down both sides, a turbine vent sits near the high point, and smaller penetrations appear farther along the slope. A gutter follows the right-hand edge. The close view makes it easier to distinguish the broad shingle surfaces from the separate caps and penetration details.
For a similar roof, a useful proposal should name the cap product and explain how the roof edge and existing penetrations will be handled. The ventilation discussion should also cover where replacement air enters the attic, rather than focusing only on the equipment visible above the shingles. Ask for a written material and ventilation schedule before installation so last-minute selections can be resolved clearly.
Project completion
The project was recorded as job complete on August 21, 2026, and closed on August 24. Its roof photograph was taken during the afternoon of August 21. This case documents the signed material selection and visible roof details; it does not establish a specific quantity of replaced decking or measured attic-airflow improvement.
The signed proposal included a FORTIFIED scope. An issued IBHS designation has not been verified for this case.
Planning a similar project?
- Are field shingles and hip or ridge caps named in the agreement?
- How will intake and exhaust ventilation be evaluated together?
- When are final colors and any decking changes confirmed?